Hard water on the Wasatch Front leaves minerals in the bottom of your tank. Over time that sediment makes the heater noisy, slows heating, and shortens its life. A once-a-year flush helps.

You’ll Need

  • A garden hose
  • A floor drain, or a spot outside where hot water can safely drain
  • Gloves

Steps

  1. Turn off the heat source. Gas: set the control to “Pilot” or “Vacation.” Electric: switch off the breaker.
  2. Let the water cool for a few hours if you can. Tank water can scald.
  3. Close the cold-water supply valve at the top of the heater.
  4. Attach the hose to the drain valve at the bottom and run it to your drain.
  5. Open a hot-water faucet somewhere in the house so air can enter the tank.
  6. Open the drain valve and let the tank empty.
  7. Stir up the sediment: briefly open the cold supply, let it flush through, and repeat until the water runs clear.
  8. Close the drain valve, remove the hose, and open the cold supply to refill.
  9. Wait until water flows steadily from the open hot faucet. This means the tank is full. Never power an electric heater with an empty tank.
  10. Restore gas or power and close the faucet.

When to Call a Pro

  • The drain valve won’t open, won’t close, or keeps dripping
  • Water is leaking from the tank itself
  • The heater is more than 10 to 12 years old, or you see rust in the water
  • Tankless units need descaling with a pump kit. We do that too.

RATHER HAVE A PRO DO IT?

Our technicians handle this every day for homes and businesses across Utah.

Book Now or call 801.266.3361

Safety first: turn off power or gas before working on equipment. If you smell gas, leave the building and call your gas company’s emergency line from outside. If you’re ever unsure, stop and call a licensed pro.

Book Now